Previous Topic

Next Topic

Book Contents

Book Index

Batch Mode Compare to Norm

The PNEURO tool offers the Compare to Norm batch facility which is useful when several studies need to be analyzed. The batch mode allows performing the spatial normalization - which is the time-consuming processing step of the whole analysis - for a list of studies and save the normalized images for a later, interactive comparison analysis. It is also possible to perform the comparison analysis at the same time and save its results, but this unsupervised mode is not recommended due to the potential failure of spatial normalization.

Note: The creation of the Brain Norm database is requested for running the batch. This have to be prepared beforehand as explain in the Brain Norm Creation section.

Batch mode is started using the corresponding entry in the Batch Mode menu:

BatchModeC2NEntry

and displays the following dialog window.

C2NBatchModeInterface

There are numbered sections in the dialog which must be configured appropriately:

1. Select Norm

The Brain Norm against which the data should be compared can be configured on this section using the Button ... button. The images related to the selected Brain Norm are available for inspection on the bottom. The list selection allows switching between the different series such as the normalization TEMPLATE, the normalization and result MASK, as well as the NORM image.

2. Set Input(s)

In this section the studies to be normalized are defined. Please first select the data format (in the example: Database) and then add the files to the list to be processed using the Set files button. Note the button Input Format Settings which allows configuring optional pre-processing steps, such as A-P mirroring, smoothing, time-averaging, etc. Direct loading disables these options.

3. Normalization Parameters

The Normalize Input(s) check defines whether the input images need to be spatially normalized (this is not necessary if previously normalized images are selected), and the check Save Normalization Results whether the resulting images are saved.

4. Comparison Parameters

This section is only relevant if the user wants to perform the comparison analysis in unsupervised mode, which is not recommended. All the comparison results can be saved for post-batch reviewing.

5. Save Images As

If result images have been configured for saving, the format defined in this section will be applied. First select the data format (recommended is the Database), then configure additional parameters of that format. As an additional option, the Patient, Study or Series Data can be replaced.

After the configuration is complete, the 6. Run button can be activated to initiate batch processing.