|
|
|
|
|
The next tab shows the blood preprocessing Results. In most of the cases, the correction of the blood data will be performed outside of PXMOD, for instance in PKIN. Correspondingly, the Original blood data and the Corrected blood data are typically identical as in the example below.
The models for H215O are very sensitive to the delay and dispersion of the input curve and therefore include corresponding corrections. In this case the Results page shows much more information. Note that the blood curves and tissue TACs can be shown on two panels (Blood, TAC) as in the example above, or on a single panel as in the water example below.
How To Continue
There is nothing else to do on this page than to inspect the results. If the outcome is ok, proceed to the model preprocessing step with the Set Model Preprocessing Parameters button.